How to Replace a Dishwasher Door Latch — Step-by-Step Instructions
Kill the breaker — the latch microswitches carry line voltage, and the door panel exposes the control wiring.
Tools
- Torx or Phillips screwdriver
- Phone camera
Parts
- Door latch assembly for your model
Step by step
-
1 Open the inner door panel
With the door open, remove the ring of screws around the inner panel edge (often Torx). Close the latch, then separate the outer panel carefully — the control panel wiring stays attached, so lean it forward gently.
-
2 Find the latch at the top center
The latch assembly with its microswitches sits at the door’s top edge. Photograph the wiring orientation.
-
3 Swap the assembly
Unclip or unscrew the old latch, transfer the wires to the same terminals on the new one, and seat it in the same position.
-
4 Reassemble and align
Panel screws back in, then close the door: it should latch with a positive click, no slamming. If it misses the strike, loosen the strike plate and adjust.
-
5 Test a full cycle
The true test is a wash that runs start to finish without the door fault reappearing — bump the door mid-cycle to be sure.
If a new latch still won’t register, the door switch circuit or control is at fault — hand the meter work to a pro before buying more parts. If you'd rather skip it entirely, find a dishwasher repair pro near you →
Step-by-step instructions for your exact model
The same repair, tailored with your machine's error codes, known quirks, and typical costs.
What this repair costs professionally
Find a dishwasher repair pro near you.
Browse verified independent appliance repair companies by city — ratings, hours, and phone numbers, no middleman.