How to Replace the Lid Lock on a Maytag MVWC565FW Washer, Step by Step Instructions
Step by step instructions for the Maytag MVWC565FW (top load washer (vmw platform)). Parts and access points can differ a little by production year. The steps below cover the common layout for this platform, and the model notes flag its quirks.
You can replace a washer lid lock on a Maytag MVWC565FW yourself in 30 to 45 minutes. Difficulty is easy. A pro charges $100 to $250.
- 5 steps, 30 to 45 minutes, easy difficulty.
- Tools you need are putty knife, screwdriver or socket set, phone camera.
- Parts to buy are lid lock assembly for your model number.
- Unplug the machine before you start.
Unplug the washer. Never bypass or jumper a lid lock permanently, it’s the interlock that keeps the drum from spinning with the lid open.
Tools
- Putty knife
- Screwdriver or socket set
- Phone camera
Parts
- Lid lock assembly for your model number
Step by step
-
1 Confirm the lock is actually the problem
Check the outlet and breaker first, and note the symptom. Flashing lid lock light with clicks is the classic failed lock signature on most top loaders.
-
2 Open the top panel
On most top loaders the whole top hinges up. Slide a putty knife under the front corners of the lid panel to release the spring clips, or remove the rear screws, then tilt the top back.
-
3 Unplug the old lock
The lock sits under the top panel at the lid opening’s front edge, one wiring plug and two or three screws.
-
4 Fit the new lock
Screw the new assembly into the same spot, connect the plug until it clicks, and route the harness exactly where the old one sat.
-
5 Reassemble and test
Snap the top down, plug in, and start a cycle. You should hear the lock engage and see the lid light go solid.
Maytag MVWC565FW notes & error codes
Identical diagnostics to the Whirlpool WTW series, any tech who knows VMW machines can fix this in one visit with common truck stock.
| Code | What it means |
|---|---|
| F7 E1 | Speed sensor / actuator |
| F7 E5 | Shifter position fault |
| F5 E2 / E3 | Lid lock faults |
| F9 E1 | Long drain |
Full details for this machine, common problems, causes, and costs, are in the Maytag MVWC565FW repair guide. The general version of these instructions is here.
If a new lock still flashes errors, the control board or its harness is suspect, that diagnosis is faster (and cheaper) with a tech’s meter than with parts roulette. If you'd rather skip it entirely, find a washer repair pro near you
What this repair costs professionally
Find a washer repair pro near you.
Browse independent appliance repair companies by city, ratings, hours, and phone numbers, no middleman.