How to Replace the Lid Lock on a Maytag MVWP586GW Washer, Step by Step Instructions
Step by step instructions for the Maytag MVWP586GW (top load washer, commercial grade, mechanical controls). Parts and access points can differ a little by production year. The steps below cover the common layout for this platform, and the model notes flag its quirks.
You can replace a washer lid lock on a Maytag MVWP586GW yourself in 30 to 45 minutes. Difficulty is easy. A pro charges $100 to $250.
- 5 steps, 30 to 45 minutes, easy difficulty.
- Tools you need are putty knife, screwdriver or socket set, phone camera.
- Parts to buy are lid lock assembly for your model number.
- Unplug the machine before you start.
Unplug the washer. Never bypass or jumper a lid lock permanently, it’s the interlock that keeps the drum from spinning with the lid open.
Tools
- Putty knife
- Screwdriver or socket set
- Phone camera
Parts
- Lid lock assembly for your model number
Step by step
-
1 Confirm the lock is actually the problem
Check the outlet and breaker first, and note the symptom. Flashing lid lock light with clicks is the classic failed lock signature on most top loaders.
-
2 Open the top panel
On most top loaders the whole top hinges up. Slide a putty knife under the front corners of the lid panel to release the spring clips, or remove the rear screws, then tilt the top back.
-
3 Unplug the old lock
The lock sits under the top panel at the lid opening’s front edge, one wiring plug and two or three screws.
-
4 Fit the new lock
Screw the new assembly into the same spot, connect the plug until it clicks, and route the harness exactly where the old one sat.
-
5 Reassemble and test
Snap the top down, plug in, and start a cycle. You should hear the lock engage and see the lid light go solid.
Maytag MVWP586GW notes & error codes
Machines with mechanical timers and no boards are the easiest in the category to diagnose and among the cheapest to keep running. The ten year parts warranty on the motor and basket makes a mid life repair decision easier than it looks on paper, always check coverage first.
| Code | What it means |
|---|---|
| Mechanical controls | Dial timer machine with no electronic fault codes, diagnosis is by measurement |
| Lid switch | A dead machine is most often the lid switch rather than the timer |
Full details for this machine, common problems, causes, and costs, are in the Maytag MVWP586GW repair guide. The general version of these instructions is here.
If a new lock still flashes errors, the control board or its harness is suspect, that diagnosis is faster (and cheaper) with a tech’s meter than with parts roulette. If you'd rather skip it entirely, find a washer repair pro near you
What this repair costs professionally
Find a washer repair pro near you.
Browse independent appliance repair companies by city, ratings, hours, and phone numbers, no middleman.