How to Replace the Drain Pump on a Maytag MHW5630HW Washer, Step by Step Instructions
Step by step instructions for the Maytag MHW5630HW (front load washer). Parts and access points can differ a little by production year. The steps below cover the common layout for this platform, and the model notes flag its quirks.
You can replace a washer drain pump on a Maytag MHW5630HW yourself in 45 to 90 minutes. Difficulty is moderate. A pro charges $130 to $300.
- 5 steps, 45 to 90 minutes, moderate difficulty.
- Tools you need are nut driver / socket set, pliers for hose clamps, shallow pan + towels.
- Parts to buy are drain pump matched to your model number.
- Unplug the machine before you start.
Unplug the washer and drain it first (see the pump filter guide for the drain hose trick). Residual water WILL come out of the hoses, pan and towels ready.
Tools
- Nut driver / socket set
- Pliers for hose clamps
- Shallow pan + towels
- Phone camera
Parts
- Drain pump matched to your model number
Step by step
-
1 Confirm the pump is dead
Clean the filter first, half of "dead pump" calls are a clogged trap. A pump that hums with a clear filter, grinds, or is silent during drain is genuinely done.
-
2 Get access
Front loaders. Remove the lower front panel (a few screws under the lip). Top loaders. Tilt the machine back or remove the rear/front panel per your model, the pump sits at the tub’s lowest point.
-
3 Photograph, then disconnect
Photo the hose routing and wiring plug. Release the spring clamps with pliers, wiggle the hoses off into your pan, and unplug the electrical connector.
-
4 Swap the pump
Most pumps mount with 2 to 3 screws or a twist lock bayonet. Transfer to the new pump, reconnect hoses (clamps seated past the bead) and the plug.
-
5 Leak test before closing
Run a small fill and a drain cycle with the panel still off and watch every connection, then button it up.
Maytag MHW5630HW notes & error codes
Parts cross with Whirlpool WFW models, the badge premium doesn’t follow it into the parts catalog. Note on bearings. Whirlpool does not sell a rear bearing and seal kit for this platform, the bearing is pressed into the outer tub and is serviced only as a complete outer tub assembly, which is why a bearing quote here is so much higher than on a machine with a serviceable kit. Legacy Duet bearing kits sold online fit older platforms and will not fit this one.
| Code | What it means |
|---|---|
| F9 E1 | Drain |
| F5 E2 | Door lock |
| F0 E2 | Suds |
| F7 E1 | Motor sensor |
Full details for this machine, common problems, causes, and costs, are in the Maytag MHW5630HW repair guide. The general version of these instructions is here.
If a new pump still won’t run, the control board isn’t sending it power, that diagnosis needs a meter and a wiring diagram, which is a fast pro visit instead of a parts guessing game. If you'd rather skip it entirely, find a washer repair pro near you
What this repair costs professionally
Find a washer repair pro near you.
Browse independent appliance repair companies by city, ratings, hours, and phone numbers, no middleman.