How to Replace a Washer Drain Pump — Step-by-Step Instructions
Unplug the washer and drain it first (see the pump-filter guide for the drain hose trick). Residual water WILL come out of the hoses — pan and towels ready.
Tools
- Nut driver / socket set
- Pliers for hose clamps
- Shallow pan + towels
- Phone camera
Parts
- Drain pump matched to your model number
Step by step
-
1 Confirm the pump is dead
Clean the filter first — half of "dead pump" calls are a clogged trap. A pump that hums with a clear filter, grinds, or is silent during drain is genuinely done.
-
2 Get access
Front-loaders: remove the lower front panel (a few screws under the lip). Top-loaders: tilt the machine back or remove the rear/front panel per your model — the pump sits at the tub’s lowest point.
-
3 Photograph, then disconnect
Photo the hose routing and wiring plug. Release the spring clamps with pliers, wiggle the hoses off into your pan, and unplug the electrical connector.
-
4 Swap the pump
Most pumps mount with 2–3 screws or a twist-lock bayonet. Transfer to the new pump, reconnect hoses (clamps seated past the bead) and the plug.
-
5 Leak-test before closing
Run a small fill and a drain cycle with the panel still off and watch every connection, then button it up.
If a new pump still won’t run, the control board isn’t sending it power — that diagnosis needs a meter and a wiring diagram, which is a fast pro visit instead of a parts guessing game. If you'd rather skip it entirely, find a washer repair pro near you →
Step-by-step instructions for your exact model
The same repair, tailored with your machine's error codes, known quirks, and typical costs.
What this repair costs professionally
Find a washer repair pro near you.
Browse verified independent appliance repair companies by city — ratings, hours, and phone numbers, no middleman.