How to Replace the Drain Pump on a Whirlpool WTW7120HW Washer — Step-by-Step Instructions
Step-by-step instructions for the Whirlpool WTW7120HW (top-load washer, smart, impeller). Parts and access points can differ slightly by production year — the steps below cover the common layout for this platform, and the model notes flag its quirks.
Unplug the washer and drain it first (see the pump-filter guide for the drain hose trick). Residual water WILL come out of the hoses — pan and towels ready.
Tools
- Nut driver / socket set
- Pliers for hose clamps
- Shallow pan + towels
- Phone camera
Parts
- Drain pump matched to your model number
Step by step
-
1 Confirm the pump is dead
Clean the filter first — half of "dead pump" calls are a clogged trap. A pump that hums with a clear filter, grinds, or is silent during drain is genuinely done.
-
2 Get access
Front-loaders: remove the lower front panel (a few screws under the lip). Top-loaders: tilt the machine back or remove the rear/front panel per your model — the pump sits at the tub’s lowest point.
-
3 Photograph, then disconnect
Photo the hose routing and wiring plug. Release the spring clamps with pliers, wiggle the hoses off into your pan, and unplug the electrical connector.
-
4 Swap the pump
Most pumps mount with 2–3 screws or a twist-lock bayonet. Transfer to the new pump, reconnect hoses (clamps seated past the bead) and the plug.
-
5 Leak-test before closing
Run a small fill and a drain cycle with the panel still off and watch every connection, then button it up.
Whirlpool WTW7120HW notes & error codes
Half the "broken washer" complaints on smart models are connectivity, not laundry — the machine washes fine without Wi-Fi. For real faults, it’s the same VMW parts as the cheap models.
| Code | What it means |
|---|---|
| F7 E1 / E5 | Actuator/speed faults |
| F9 E1 | Long drain |
| F5-series | Lid lock faults |
| F8 E1 | No water detected |
Full details for this machine — common problems, causes, and costs — are in the Whirlpool WTW7120HW repair guide. The general version of these instructions is here.
If a new pump still won’t run, the control board isn’t sending it power — that diagnosis needs a meter and a wiring diagram, which is a fast pro visit instead of a parts guessing game. If you'd rather skip it entirely, find a washer repair pro near you →
What this repair costs professionally
Find a washer repair pro near you.
Browse verified independent appliance repair companies by city — ratings, hours, and phone numbers, no middleman.