How to Replace the Bake Element on a Hotpoint RBS160DMWW Oven & Range, Step by Step Instructions
Step by step instructions for the Hotpoint RBS160DMWW (electric range, smooth top, 5.0 cu ft). Parts and access points can differ a little by production year. The steps below cover the common layout for this platform, and the model notes flag its quirks.
You can replace an oven bake element on a Hotpoint RBS160DMWW yourself in 30 to 45 minutes. Difficulty is easy. A pro charges $150 to $280.
- 5 steps, 30 to 45 minutes, easy difficulty.
- Tools you need are nut driver or screwdriver, flashlight, phone camera.
- Parts to buy are bake element matched to your model number.
- Unplug the machine before you start.
FLIP THE BREAKER, not just the controls, oven elements run on 240V and the terminals stay live with the oven "off." Confirm dead with a non contact tester if you have one.
Tools
- Nut driver or screwdriver
- Flashlight
- Phone camera
Parts
- Bake element matched to your model number
Step by step
-
1 Kill the power at the breaker
Ranges plug in behind the unit (unplug it) or hard wire to a double breaker (flip it). Verify the display is dead before touching anything.
-
2 Inspect the old element
Remove the racks and look at the bottom element. Blisters, breaks, or a burn spot confirm the diagnosis on sight.
-
3 Unscrew and pull forward
Two screws hold the element bracket to the back wall. Remove them and gently pull the element toward you, the two wire terminals follow it out a few inches.
-
4 Transfer the wires one at a time
Photograph first. Pull each spade connector off with pliers (grip the connector, not the wire) and seat it on the same terminal of the new element. Don’t let the wires retreat into the wall hole, clip a clothespin on them if needed.
-
5 Mount and test
Screw the bracket back, restore power, and set a 350°F bake. The new element should glow evenly within minutes. A little smoke/odor on first heat is the factory coating burning off.
Hotpoint RBS160DMWW notes & error codes
Rental grade ranges get swapped often, and the anti tip bracket is left behind more than any other part. Check it on every visit regardless of what the call was booked for.
| Code | What it means |
|---|---|
| F2 | Oven over temperature |
| F3 | Sensor circuit open |
| F4 | Sensor circuit shorted |
Full details for this machine, common problems, causes, and costs, are in the Hotpoint RBS160DMWW repair guide. The general version of these instructions is here.
If the new element doesn’t heat, the problem is upstream, a thermal fuse, sensor, or board relay, and that diagnosis wants a multimeter and a wiring diagram. If you'd rather skip it entirely, find a oven & range repair pro near you
What this repair costs professionally
Find a oven & range repair pro near you.
Browse independent appliance repair companies by city, ratings, hours, and phone numbers, no middleman.